Lift Installation Manual Top - Thyssenkrupp Levant Stair
The Levant uses a swivel seat mechanism to aid disembarkation, but the rail itself must be immovably secured. The top bracket is arguably the most critical load-bearing point in the system.
Reason: The cap prevents the carriage from sliding off the rail during installation. Premature removal can cause the 50lb carriage to fall.
The top limit switch stops the chair before it crashes into the bracket. The manual provides a step-by-step calibration: thyssenkrupp levant stair lift installation manual top
Contains the aluminum track sections, joint pins, gear rack pieces, and floor mounting brackets (feet).
Electric drill and appropriate bits (wood, concrete, or tile depending on floor material) Digital level or magnetic angle finder Tape measure and chalk line 3. Assembling and Installing the Rail The Levant uses a swivel seat mechanism to
Regular maintenance is essential to ensure the stair lift continues to operate safely and efficiently. Refer to the manufacturer's instructions for maintenance and troubleshooting guidelines.
Place the rail sections onto the stairs parallel to the wall or banister. Keep a standard clearance distance—typically 5 to 7 inches—between the edge of the rail and the wall to account for the seat width and user positioning. Step 2: Splicing the Rail Sections Premature removal can cause the 50lb carriage to fall
According to the Flow2A installation guidelines (which follow the same professional protocols), your installer will verify the following:
The Levant installation process is split into three primary phases: rail mounting, carriage placement, and seat assembly. 1. Positioning and Securing the Rail
For systems with continuous charge strips (often copper strips embedded in the rail profile), the top termination involves capping the strip to prevent short circuits. The strip must be cut cleanly, and the plastic insulator cap installed securely. If this cap falls off, the metal rail or the carriage rollers could contact the live strip, blowing the fuse in the transformer.
