Calibration is successful when the green configuration LEDs flash and the minus (-) LED stays illuminated, confirming the closed limit switch position is saved. Radio Transmitter (Remote) Matching

[230V AC Mains Wall Outlet] ---> [Factory Pre-Wired Schuko Plug] ---> [Internal Transformer] ---> [RG1 24V Control Board]

: Use the red button to enter settings; adjust with +/- buttons.

Use the arrow to move the door to the desired open position. Press Program to save the open limit.

: You must isolate high-voltage 230V supply pathways away from safety accessory lines (e.g., low-voltage photocell leads) by pushing them through separate terminal channels.

Ensure perfect horizontal alignment and tighten all, including front and rear clamping screws. 6. Installation: Door Connection (Page 6)

Ensure the garage door is mechanically sound, perfectly counterbalanced, and glides smoothly along its tracks without catching or sticking. The operator cannot compensate for defective, warped, or poorly maintained door hardware. Step-by-Step Operator Installation Assembly onto the Guide Rail

The is an electromechanical operator designed for residential sectional and up-and-over garage doors. The official 10-page manual covers technical data, preliminary checks, rail and motor installation, wiring, and maintenance. 🛠️ Installation Highlights

for sectional and up-and-over garage doors. The 10-page manual covers everything from the initial mechanical setup to electronic programming. www.homelife.it Key Installation Steps Preparation