Once the electronic level shows the instrument is within tolerance, check the laser plummet again. If it has drifted, loosen the tripod screw slightly, slide the instrument back over the mark, and re-verify level. 3. Navigating the Interface and Software
Fully charge the GEB111 batteries before first use:
If the instrument gets wet in the rain, do not store it in its closed case overnight. Leave the case open and allow the total station to air dry naturally at room temperature to prevent internal condensation. leica tcr805 total station user manual
Look through the optical (or laser) plummet and adjust the tripod legs until the crosshairs point directly at the ground mark.
By mastering the content in the user manual, you will unlock the full potential of your Leica TCR805, ensuring accurate, efficient, and safe surveying for years to come. Always refer to the official manual for specific procedures and safety information relevant to your instrument's configuration. Once the electronic level shows the instrument is
: For immediate measuring without setting up a specific job.
It provides 5-second angular accuracy and is equipped with a dual-axis compensator to automatically correct leveling inaccuracies. EDM Technology: Navigating the Interface and Software Fully charge the
Align the display parallel to two footscrews on the tribrach. Turn both screws in opposite directions simultaneously until the electronic tilt error reads near zero.
Configure the communication parameters on both the PC and the total station ( > Settings > Communication ): Baud rate: 19200 Databits: 8 Parity: None Stopbits: 1
Always organize your work by creating a dedicated job folder before taking measurements. Navigate to > Manage > Job . Select NEW (F1). Enter a unique Job Name using the alphanumeric keypad. Press OK (F4) to save. 2. Station Setup (Orientation)
Turn the instrument 90 degrees and use the third footscrew to adjust the remaining axis.