Ericsson Mini Link Cli Commands [updated] -

: Retrieves equipment details, including serial numbers, hardware types, and software versions. show alarms

set radio-link loopback far-end — Commands the remote ODU to loop back the received RF signal.

While a Node GUI is available, its configuration features are often limited compared to the depth offered by the CLI. The CLI has been the primary tool for performing serious configuration work, scripting, and large-scale maintenance for years.

The CLI operates in different modes, similar to Cisco IOS, where higher privileges are required for configuration changes. ericsson mini link cli commands

set interface ethernet speed duplex : Manually forces speed and duplex settings on a specific port.

SSH (Secure Shell) is preferred for security, though Telnet may be available on older legacy configurations. Serial Settings: Baud Rate: 9600 or 115200 (depending on NPU generation) Data bits: 8 Parity: None Stop bits: 1 Flow Control: None Navigation and System Basics

Always remember to practice the function when experimenting in a lab. This safety net allows you to try complex configurations with minimal risk. For critical production nodes, always finalize your changes with the write mem command to prevent data loss during a reboot. By combining the connectivity knowledge from this article with your own hands-on practice, you are well on your way to becoming an expert in Ericsson microwave network management. The CLI has been the primary tool for

set radio tx-power : Adjusts the output power of the transmitter, typically measured in dBm.

: Identifies the path taken by packets to a destination.

Lists: Severity (Critical, Major, Minor, Warning), ID, Description, Time. SSH (Secure Shell) is preferred for security, though

Displays hardware inventory, software versions, and current board temperatures. ping , traceroute , telnet Basic network diagnostic and reachability tools. Configuration config , write Enters configuration mode and saves changes to memory. Maintenance reload , activate

: Activates a loopback on a specific controller for path testing (use no loopback to disable). reload : Triggers a "warm restart" of the node. write : Saves the current configuration to permanent memory. DCN and Service Configuration