Use extreme caution when treating areas with impaired sensation; monitor skin frequently to prevent electrical burns.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Navigate the menu using the central controller or touch screen to select Electrotherapy Muscle Stimulation (or Pain Management). Channel Setup:
| Error Display | Meaning | Action | |---------------|---------|--------| | | Electrode cable not connected or broken electrode lead. | Check plug connections. Test cable continuity with a multimeter. | | "Output High" | Intensity exceeds the safe limit for current path (e.g., electrodes too close together). | Reduce intensity immediately. Reposition electrodes. | | Internal Beeping + Blank Screen | Thermal overload or internal fuse failure. | Power off for 15 minutes. If persists, return for service. | | "E-01" | Microprocessor communication error. | Cycle power. If repeated, factory reset required. | endomed 582 user manual
Pacemakers, implanted cardioverter-defibrillators (ICDs), or other electronic implants.
The manual stresses that the Endomed 582 should and that the therapist must always keep the patient in sight during treatment.
Controls to adjust the balance between channels during 4-pole interferential therapy. 3. Step-by-Step Programming and Treatment Setup Use extreme caution when treating areas with impaired
| Control Element | Function | |----------------|----------| | | Shows intensity (mA), frequency (Hz), treatment time, and suction mode. | | Channel A/B Select | Toggles control between the two independent output channels. | | Intensity Knobs (x2) | Large rotary dials for fine adjustment of channel A and B intensities. | | Frequency ± | Adjusts the beat frequency (Amplitude Modulation Frequency) from 0–250 Hz. | | Time ± | Sets treatment duration from 1–60 minutes. | | Mode (M) | Cycles through Continuous, Cyclic (6s on/6s off), and Frequency Swing modes. | | Start/Stop | Initiates or pauses the current therapy session. |
Store patient cables in loose coils. Never bend, kink, or tightly wrap the cables around the machine handles, as this fractures the internal copper wiring.
For immediate viewing or downloading of the specific "ID" version of the manual, community-uploaded copies are available: Scribd (Endomed 582 ID): If you share with third parties, their policies apply
Interferential (2-pole and 4-pole), TENS (Asymmetrical, Symmetrical, Burst), Galvanic (Direct Current), and Diadynamic currents. Channels: 2 completely isolated channels.
Securely apply the electrodes to the target treatment area using elastic straps or adhesive properties. Connect the lead wires to the electrodes and insert them into Channel 1 and/or Channel 2. Step 3: Parameter Selection
Understanding the technical boundaries of your equipment ensures patient safety and therapeutic efficacy. Specification 100–240 V AC ( ±plus or minus 10%), 50/60 Hz Power Consumption Max. 60 VA Channels 2, completely isolated from each other and from earth Output Characteristics Constant Current (CC) or Constant Voltage (CV) Carrier Frequency 2 kHz, 4 kHz, and 10 kHz (for medium-frequency currents) Low Frequency Range 0 to 150 Hz Timer 0 to 60 minutes, linked to automatic intensity shut-off Safety Class Class I, Type BF according to IEC 60601-1 3. Control Panel and Interface Layout