When updating to newer iterations of CM2 software modules, always use the default file directory paths to keep your SCR communication registries synchronized.

The Infinity-Box Chinese Miracle II (CM2) SCR/SPD-RDA module version 1.07, released in December 2020, introduces enhanced servicing support for UniSoc and RDA Micro chipsets, notably covering the RDA8955 line used in IoT and wearable devices. This update enables critical operations such as flashing, security code removal, and memory formatting, while requiring Dongle Firmware version 0146. Read the full update details at Infinity-Box 2020-12-15 - Infinity Chinese Miracle II SCR/SPD-RDA v1.07

To deploy the Chinese Miracle SCR Module Ver 1.07 successfully, the host environment must meet specific hardware and software benchmarks. System Requirements

Navigate to the "Flash" or "Service" tab depending on your goal (e.g., "Read Firmware" or "Format FS").

The module is highly specialized for specific, low-cost chipsets. The primary supported CPUs in v1.07 include: SC6530, SC6531, SC6531(A/C/D), SC68xx, SC770x. UniSoc: SC6531E, SC6533, SC6533G, SC770x.

Understanding Chinese Miracle SCR Module Ver 107: A Complete Guide to Smart Card Reader Drivers

Complete Guide to Chinese Miracle SCR Module Ver 1.07: Features, Setup, and Troubleshooting

Correct USB drivers installed (SPD/MTK/RDA drivers depending on the target phone).

: Integrates directly with the Infinity Dongle Manager for seamless card identification. Step-by-Step Installation Guide

Technicians can read a complete, bit-for-bit backup of the device’s internal storage. This is crucial for creating working firmware copies from functional devices.

Specifically targets the RDA8955x line, an affordable SoC often found in cheap smartwatches and feature phones with GPS support.

This is a common error in older versions. If you encounter this with Ver 107: