Annoy Tools Cnc Board Manual Pdf
+-------------------------------------------------------------+ | [DC Power Input] [Power Switch] [Type-C/USB Interface] | | 12V-24V (or 48V) | | | | +--------------+ +--------------+ +--------------+ | | | X-Axis Drive | | Y-Axis Drive | | Z-Axis Drive | | | +--------------+ +--------------+ +--------------+ | | | | [X-Limit] [Y-Limit] [Z-Limit] [Probe] [Emergency Stop] | | | | [Laser Output: 12V/24V TTL] [Spindle Motor Interface] | | | | [Offline Port] | +-------------------------------------------------------------+ Axis and Stepper Motor Drivers
Search YouTube for [Your Board Name] setup .
Premium, highly capable software for precise laser setups. Driver Installation annoy tools cnc board manual pdf
This usually means a limit switch was triggered. Use the "$X" command to unlock the machine.
Disclaimer: This guide is for informational purposes. Always verify wiring with a multimeter and follow electrical safety guidelines. The author is not affiliated with Annoy Tools. Use the "$X" command to unlock the machine
Default recommended for smooth motion: All jumpers installed under all drivers = 1/16 microstep.
Annoy Tools boards run on GRBL firmware. To communicate with the board, you will need a G-code sender like Candle, Universal Gcode Sender (UGS), or LaserGRBL. Set your software to 115200. The author is not affiliated with Annoy Tools
Before powering on your board, familiarize yourself with the physical ports. Connecting a wire to the wrong pin can permanently damage the board. Port Label 2-pin / Barrel Main power input (12V-24V). X / Y / Z Stepper motor outputs. Laser PWM signal, Ground, and 12V power for laser modules. Spindle DC motor output (controlled via MOSFET). Limit X/Y/Z Input pins for mechanical endstop switches. Offline Serial communication port for LCD offline controllers. 3. Wiring Step-by-Step
| Symptom | Likely Fix | |---------|-------------| | No movement | Check motor wiring order (A+, A-, B+, B-) | | USB not recognized | Reinstall CH340 driver, try different USB cable | | Spindle won’t turn | Send M3 S10000 ; check $30 and $31 | | Axis moves wrong direction | Swap one coil (e.g., A+ with A-) OR set $3=3 (invert dir pins) | | Homing fails | Check limit switch wiring and $21 , $22 , $23 |
Ultimate Guide to Annoy Tools CNC Control Boards: Wiring, Setup, and Troubleshooting