Acer Q65h2-am V1.1 | Manual

The jumper sits on a 3-pin block. Move the plastic jumper cap from the default over to Pins 2-3 (Clear) .

| Jumper | Function | |---------|------------------------------------------------| | (CLR_CMOS) | Near the coin cell battery – short pins 2-3 to clear, then back to 1-2. | | ME_UPDATE | Rarely touched – used for Intel Management Engine recovery. | | PSWD | Two-pin jumper – remove to clear BIOS password. |

3 x internal USB 2.0 headers supporting up to 6 additional front-panel or internal expansion ports. Step-by-Step Installation and Wiring Guide Troubleshooting the Front Panel Header Pinout acer q65h2-am v1.1 manual

4x 240-pin DDR3 DIMM slots (Dual Channel, max 16GB at 1333 MHz). Expansion: 1x PCIe x16 (2.0) 2x PCIe x1 1x Legacy PCI slot

The Acer Q65H2-AM V1.1 operates on the or Intel Q67 chipset architecture. It is engineered primarily for stability and legacy device compatibility. Component / Feature Supported Specifications CPU Socket Intel LGA 1155 (Socket H2) Supported Processors The jumper sits on a 3-pin block

If you are assembling a new system using this motherboard or transferring it to a new case, use the following guidelines: 1. Processor Installation

5 x SATA II 3.0 Gb/s connectors (Some board revisions feature 1x SATA III) Realtek High Definition Audio Network Interface Intel Gigabit Ethernet (10/100/1000 Mbps) Form Factor Micro-ATX (244mm x 244mm) Processor and Memory Installation | | ME_UPDATE | Rarely touched – used

You can reset the BIOS to its default state by locating the Clear CMOS jumper (CLRCMOS1) on the motherboard. To do this, turn off and unplug your computer, then use a jumper cap to short pins 2 and 3 for about 5 seconds. Do not clear CMOS immediately after a BIOS update.

Here are a few tips and tricks to help you get the most out of the Acer Q65H2-AM V1.1 manual:

The board provides a solid array of legacy and digital connections: 1 x VGA, 1 x DVI-D, and 1 x DisplayPort. USB: 6 x USB 2.0 ports. Networking: 1 x RJ-45 Gigabit Ethernet port.

1 x RS-232 Serial COM port, 1 x RJ-45 Gigabit Ethernet port, and a standard 3-jack Analog Audio configuration. Internal Connections